DIY PCB etching

666666
Hello World ,In this post I will be showing how make your own printed circuit board from your house in few simple steps

What is a PCB?

A printed circuit board (PCB) mechanically supports and electrically connects electronic components using conductive tracks, pads and other features etched from copper sheets laminated onto a non-conductive substrate. A printed circuit board has pre-designed copper tracks on a conducting sheet. The pre-defined tracks reduce the wiring thereby reducing the faults arising due to lose connections. One needs to simply place the components on the PCB and solder them.

What you will need 

Software Required || Not really Required for smaller circuits || Using this software you can make the circuit for your board .I will suggest some software

Design your layout using the any those CAD software.Print the mirrored layout  of your circuit in a glossy paper/magazine paper.

Video Tutorial

Prepare your Board

  1. Cut the copper clad according to the size of layout using a cutter
  2. Clean the board by scrubbing the board by a steel scrub .Scrub till shines wells,This removes the oxide layer
  3. Place the  copper side facing up. Align paper on to the board with the printing facing the copper. Do not allow it to move.
  4. Press the iron box on the back of the paper make sure you give equal pressure at all place .Repeat the process for 4-5 minutes
  5. Dip the board in cold water soak the board in cold water for 5 minutes
  6. Peel the wet paper from the board leaving only the print.If the paper is not comes of easily gently scrub using your finger
  7. Once the whole paper is removed from the board sometimes there will be some place where the ink has not transferred  properly use a permanent marker for draw the circuit

Alternate Method for preparing small board

If you making not to big or complex board the you can use a permanent marker for drawing the layout of your board

PREPARING THE ETCHING SOLUTION WARNING!!!!!!

Use gloves while preparing the solution

  1. Take a bowl and fill 500ml of water to it.
  2. Add 150-200g of Ferric chloride powder to the water ,mix the solution well

Now the etching solution is ready for etching the board. Now take the board to which the circuit has been transferred and dip the board on to the solution keeping the copper facing up Gently shake the shake to and fro till the entire unwanted copper is removed from the board.Once the whole is completely etched take the board from the solution and clean it with fresh water .For removing the remaining ink ,soak a piece of cloth or cotton in thinner(nail polish remover) and wipe the board

DRILLING THE HOLES

Drill the holes in you board using PCB hand drill and solder your components.While drilling make sure you hold the driller perpendicular to the surface of the board otherwise there is chance in breaking the bit
DSC08282

pcb (7)

Advertisements

2 Comments Add yours

  1. Bill says:

    Which is the software you used for making the pcb design ?

    Like

    1. Mayoogh says:

      Its Fritizing
      You can dowload it from here http://fritzing.org/download/

      Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s